Self-assembled InAs quantum-dot single-photon source Created 2026-10-18 Updated 2026-10-20
A quantum dot of InAs embedded in gallium arsenide confines injected electrons and electron holes. Strain-driven island formation supplies dots with lateral dimensions of order tens of nanometres and heights of a few nanometres. In an electrically driven implementation, a dot lies in a junction's intrinsic region. Selecting one dot spatially and one radiative line spectrally turns discrete exciton recombination into a single-photon source. Pulsed injection must avoid re-excitation during the same collection window.
Semiconductor Created 2026-10-05 Updated 2026-10-20
A semiconductor has an electronic band gap and a conductivity strongly affected by temperature, impurities and carrier injection. Optical absorption can create mobile electrons and holes, enabling a photodiode.
The useful feature of a semiconductor is that its charge carrier population can be controlled. Semiconductor doping changes the supply of mobile electrons or electron holes; carrier injection changes their population away from thermal equilibrium. A transistor turns that control into an electronic amplifier: a small input signal controls a larger flow of supplied energy.
For a uniform semiconductor in a weak electric field, a simple drift model writes its electrical conductivity asHere is the elementary charge, are the number densities of mobile electrons and electron holes, and their positive charge carrier mobilities. The two contributions add because opposite electric charges drift in opposite directions and therefore carry electric current in the same direction. This model assumes fixed temperature and mobilities and omits diffusion from density gradients.
An original dimensionless example isolates the effect of carrier injection. Suppose initially and . Adding equal excess populations gives , even though the added electron holes remain a minority carrier population. A semiconductor can respond strongly to a small injected population without changing its underlying band gap.
Semiconductor carrier freeze-out Created 2026-10-20 Updated 2026-10-20
At sufficiently low temperature, thermal ionization of shallow dopants becomes inefficient, reducing the mobile carrier density. An acceptor-doped sample may then have many neutral acceptors and few mobile electron holes. Extracting an activation energy requires a model of dopant ionization and compensation; the mobile density need not have the same simple activation exponent in every compensation regime.
Semiconductor inversion layer 2026-10-18
A near-surface region whose predominant mobile charge carrier species is opposite to that in the interior: for example a layer rich in electron holes on an n-type semiconductor.
Semiconductor mass-action law Created 2026-10-18 Updated 2026-10-20
In thermal equilibrium, nondegenerate conduction electrons and valence electron holes share one chemical potential. Multiplying by cancels that chemical potential:This relation remains valid with semiconductor doping under the stated assumptions. Equality of the two individual densities, , additionally requires the intrinsic neutral case. Separate electron and hole quasi-Fermi levels in nonequilibrium need not obey this equilibrium product.
With one parabolic valley and two spin states at each band edge, the prefactor multiplying in the product is . Both populations must be nondegenerate; the Pauli reduction of the pinned-edge mass-action product quantifies a failure of the classical approximation.
Shockley-Queisser limit Created 2026-10-18 Updated 2026-10-20
The Shockley-Queisser limit is the radiative conversion-efficiency bound for an ideal single-junction solar cell, with one collected electron-electron hole pair per absorbed above-gap photon, carrier thermalization, and radiative recombination required by the reverse optical process. Photons below the band gap are not absorbed, while excess photon energy above it is thermalized. Maximizing the electrical power over the operating electric potential difference and then the band gap gives a ceiling of roughly thirty percent for ordinary unconcentrated sunlight; its precise value depends on the incident spectrum, cell temperature and emission geometry. The original calculation by William Shockley and Hans-Joachim Queisser obtained approximately at for a blackbody source and a cell at .[ref]
Solar cell Created 2026-10-18 Updated 2026-11-05
A solar cell converts incident light into electrical power through the photovoltaic effect. A semiconductor p-n junction separates and collects photogenerated electrons and electron holes. An ideal illuminated junction has output current densityHere is the short-circuit current density, is the diode saturation current, and is the open-circuit electric potential difference. The conversion efficiency is the largest delivered divided by the incident power per unit area; the short-circuit and open-circuit operating points themselves deliver zero power.
Split-off valence band 2026-10-18
Spin-orbit coupling separates the valence states from the upper manifold at the zone centre in common cubic semiconductors. If its maximum lies below the upper valence band edge, its thermal electron hole population is suppressed by apart from effective density of states factors. Neglect requires ; it is not valid at every temperature or in every material.
Tomasz Kazimierczuk Created 2026-10-13 Updated 2026-11-05
A researcher in semiconductor optics whose team observed Rydberg excitons in cuprous oxide in 2014. These bound electron–electron hole pairs reached principal quantum numbers as high as 25 and extended over micrometers, allowing a crystal to host excitations resembling highly excited hydrogen atoms.[ref]
Trap-assisted electron-hole recombination 2026-10-20
A localized electronic defect can capture a conduction electron and subsequently an electron hole, or the reverse sequence, returning to its original charge state. Energy is transferred to the lattice rather than an emitted photon. The two-step process can remove an electron-hole pair even when direct band-to-band photon emission is inefficient. Its rate depends on trap density, occupation and both capture rates; a single trapping event is not necessarily completed recombination.
Two-carrier Hall coefficient Created 2026-10-18 Updated 2026-10-20
For isotropic electrons and electron holes with positive mobilities, adding their weak-field electrical conductivity tensors and imposing zero transverse total current givesThe Hall coefficient changes sign at . Carrier abundance alone does not fix the sign; mobilities enter quadratically. The formula assumes , , independent semiclassical carriers, and no anomalous Hall contribution.
Type-I band alignment Created 2026-10-18 Updated 2026-10-20
A type-I band alignment confines electrons and electron holes together: its inner conduction band edge is lower, its valence band edge higher.[ref]
Nobel Lecture: Quasielectric fields and band offsets: teaching electrons new tricks by Herbert Kroemer. §IV, Figs. 6–8, pp. 786–787
In the chosen band offset example, the electron barrier is , while the electron hole barrier is . A hole's excitation energy is measured downward from a valence band maximum: reversing that convention would incorrectly make the two barriers appear to repel opposite carriers. An electrostatic shift moves both electron energy band edges together; changing the band gap also changes their separation. Thus material composition supplies a control beyond the electric potential alone.
Valence band 2026-10-14
In the simple semiconductor description, the highest occupied energy band of the unexcited crystal at zero temperature. A missing occupant is an electron hole.