Work in the locally planar shock frame, taking towards the surface. For a stationary normal shock wave with negligible radiative loss inside the discontinuity, the Rankine-Hugoniot conditions for a perfect gas express conservation of mass, conservation of momentum, and conservation of energy per unit area as
Here is specific enthalpy, including the pressure work; using only internal energy would omit that work. The gravitational potential is continuous across an infinitesimally thin front. For cold upstream gas, and are negligible, while a monatomic gas has and .
The hydrodynamic equations apply to flow parallel to the guiding magnetic field when its stress contributions cancel across the front. An oblique magnetohydrodynamic shock requires magnetic stresses and Poynting flux; a radiation-mediated front or appreciable escaping radiation requires the corresponding radiative momentum and energy flux terms. These are additional physics, not terms hidden in here.
For , expand the exponential in the thermal free-free emissivity:
The energy emitted per unit frequency is therefore approximately flat, with the weak Gaunt factor dependence superposed. At these low photon energies, most of the thermal electrons can participate in emission; there is no exponentially small population threshold.
For , the spectrum turns down approximately as , apart from the Gaunt factor. Conservation of energy requires an emitting electron to supply at least . The high-energy tail of its Maxwell-Boltzmann distribution is exponentially rare, which produces this cutoff.
“Flat” refers to , an energy spectrum per unit frequency. The emitted photon number spectrum instead contains , while energy per logarithmic frequency interval is . At sufficiently low frequency the plasma can also become optically thick to free-free absorption; the given optically thin emissivity is then not the escaping spectrum.
The coefficient is power per unit volume, frequency and solid angle. For uniform, optically thin, isotropic emission from , the spectral luminosity is . With photon energy , conservation of energy and the change of spectral variable give
Thus
The outside integrates over emitted solid angle; changes radiated energy to a photon count, and is the Jacobian determinant from frequency to energy.
With in and in joules, this formula produces . To compare with counts per , multiply by . Equivalently, the conversion cancels the same joule-per- factor in : one can use the numerical in in the factor, retain in , and express in in the exponential. The radius in the volume must still be converted to metres because is per .
In the rest frame, conservation of energy would require , whereas conservation of momentum would require the photon momentum to vanish. These contradict . More generally, four-momentum conservation would equate the initial massive four-momentum to a null four-momentum, although their Minkowski norms differ:
An isolated massive particle cannot decay into one photon in any inertial frame. Directly, a laboratory speed gives and ; matching a photon would require , hence . Recoil against another object could change the kinematics, but would introduce an additional participant.
Let be the gravitational acceleration, and let denote positive downward depth. For a frictionless particle released from rest, conservation of energy gives . The arc length element of is , so the travel time and length are
For a finite-time single arch, require in , , and interpret the endpoint integrals improperly. At a regular constrained minimizer with , the Lagrange multiplier rule for an isoperimetric constraint makes stationary. Dropping the constant gives
For the constraint is regular under interior variations: if its first variation vanished for every compactly supported variation, the Euler-Lagrange equation for would force constant, hence and , a contradiction. Thus the multiplier is justified for a nondegenerate arch.
The printed case is degenerate. Since , equality of the length with the horizontal separation forces and . A particle initially at rest then has no tangential gravitational acceleration and cannot complete the trip. Its travel time is infinite. The finite-time calculation therefore concerns , with endpoint regularity qualified below.
Take a stationary initial electron of mass , a photon incident along , and a nonrelativistic recoil velocity of magnitude . Choose above for the scattered photon and below for the electron. Conservation of momentum gives
The electron's unchanged rest energy cancels in conservation of energy, leaving
Equivalently use and . The nonrelativistic limit requires , and treating the electron as free requires its binding energy to be negligible on the scale of the collision.
For complete photon backscatter , the electron recoils forward and momentum conservation gives
Combining this with conservation of energy and writing gives
For , the final ratio is approximately four, so
Within the stated nonrelativistic equations the unsimplified relation is implicit and has higher-order recoil corrections; the displayed final approximation is all that the small-shift assumption supports. Exact relativistic Compton recoil kinematics gives , and therefore exactly at backscatter. Agreement at leading order does not make the nonrelativistic derivation exact at arbitrary photon energy.
In the photoelectric effect, incident light ejects electrons from a material when each absorbed photon supplies sufficient energy to overcome its work function . Conservation of energy gives the maximum emitted kinetic energy,
At fixed frequency above threshold, increasing light intensity primarily increases the electron emission rate; it does not increase in the single-photon regime. Emission occurs without the long accumulation delay predicted for weak classical illumination.
Classical electromagnetism distributes incident energy continuously. By itself, that picture suggests that sufficiently intense or sufficiently long illumination could eject electrons at any frequency, and that emitted electron energies should increase with light intensity. It does not account for the observed threshold frequency and the linear dependence of on frequency with slope . Quantized photon absorption accounts for all three features.
Work in the initial rest frame of the free electron. If it absorbed a photon of positive energy , conservation of momentum would give the final electron momentum magnitude , while conservation of energy would give . But the final electron must obey the relativistic energy–momentum relation,
Combining these statements gives
which contradicts . Thus
The initial rest frame always exists for an electron, so this excludes the process in every inertial frame. Compton scattering is allowed because an outgoing photon carries additional energy and momentum. Absorption by an electron bound in matter is also possible because the rest of the system can share recoil.
After thermalization, approximate the electron and Positron as initially at rest in their centre-of-momentum frame. Their total energy is and total momentum is zero. Two photons must therefore have equal energies and opposite momenta, since . Conservation of energy gives
Residual pair momentum and electron binding cause small departures from exact collinearity and exact photon energy; the standard PET calculation neglects them.
Let the step be . Forward Euler method gives , . Applying the same map with gives , which generally differs from . It is therefore not its own inverse under time reversal.
A kick–drift–kick leapfrog integrator instead has
The step first recovers , then , then , so . This assumes a position-dependent force and the same fixed step. Newtonian mechanics is reversible; respecting that structure helps avoid artificial directional bias and often improves long-term qualitative behaviour. The usual leapfrog also has a structure preserving symplectic geometry, which supports bounded oscillatory energy error, but reversibility by itself does not imply exact conservation of energy. Adaptive stepping requires special care to preserve these properties.
The source expression is total mechanical energy in the centre-of-mass frame, not kinetic energy alone. Take as the relative speed at a large initial separation where the mutual potential is negligible. At closest approach, the radial relative velocity is zero, so conservation of angular momentum and conservation of energy give
Using eliminates :
An impact occurs when , where . Since the right side increases with positive , the collision threshold is
The mutual escape velocity is the relative speed at contact required to reach infinite separation with zero residual speed. Setting total mechanical energy to zero gives
This includes target recoil. If the given initial speed were instead at a finite non-negligible separation, its potential energy would have to be retained; would then not equal the asymptotic speed used in the focusing formula.
Expand about . Then and conservation of energy gives
Here can be signed, but the physical oscillation frequency and amplitude are nonnegative. The small-energy condition ensures that this local expansion samples only a narrow range about , provided the field varies smoothly there.
Let and . For a head-on photon and particle collision, boost to the particle's initial rest frame. The incident photon energy is . On the inverse-Compton branch , the maximal outgoing lab energy corresponds to rest-frame backscattering into the particle's forward direction. The exact Compton scattering recoil formula gives . Boosting the backscattered photon back to the lab gives
For this becomes
Only in the additional Thomson scattering limit may the denominator be neglected, yielding the printed estimate . Ultrarelativistic motion alone does not justify it. For example and would give from that estimate, exceeding the available total energy; the recoil-corrected maximum is about .
For an arbitrarily hard incident photon, maximizing over direction needs a further qualification: if , the largest outgoing photon energy is the unchanged , rather than this amplified backscattering branch. The exact photon energy gain is . Calling the outgoing energy the gain is accurate only when amplification is large. These distinctions prevent the inverse Compton scattering estimate from violating conservation of energy outside its low-rest-frame-photon-energy regime.
For causal reachability on a spatial circle, put and use a representative of the spatial circle. The lower-left panel of part c is a fundamental strip with its vertical edges identified. On the covering space the charged world line is still the solution of part b; on the quotient it is
A jump between opposite strip edges is a coordinate seam, not a discontinuity of the physical world line. At its th complete lap, , so
For , the speed increases on each return while remaining below . Its kinetic energy increases by
There is no single-valued electrostatic potential energy on a circle: the nonzero electromotive force is . A globally defined magnetic vector potential one-form instead makes the driving explicit. In an embedded circuit, Faraday's law realizes this electromotive force through changing magnetic flux. More generally an external apparatus maintaining the field supplies the increasing particle energy. In an isolated dynamical field-plus-particle system, backreaction would change the field. Thus this is not a cyclic machine extracting work from a conservative potential, and it does not violate conservation of energy.
To prove the vanishing component theorem for a Lorentz four-vector, first suppose in every inertial frame. An infinitesimal boost along spatial direction gives . It too vanishes for every , so each . If instead a specified spatial component vanishes in every frame, spatial rotations first imply that all three spatial components vanish in a chosen frame, and a boost in the specified direction then forces . Therefore
A physical consequence is that conservation of energy in every inertial frame implies full four-momentum conservation: apply the result to the difference between outgoing and incoming total four-momenta.
The statement fails for general tensors. A nonzero antisymmetric rank-two tensor has in every frame, because antisymmetry is preserved. For an off-diagonal component, the nonzero Minkowski metric is another counterexample: in all orthonormal Lorentz frames, while is certainly not zero. The transformation law can preserve structural zero components without forcing the entire tensor to vanish.
Constraint and example. A holonomic constraint can be written , with no irreducible dependence on velocities. A velocity relation is holonomic if it integrates to such an equation. For example, a particle constrained to a stationary circle satisfies , reducing its two Cartesian degrees of freedom to one angle. A nonholonomic constraint cannot be integrated in this way.
Kinematics and kinetic energy. Set . In the plane of the original diagram, choose the orbital angle positive counterclockwise from vertically downward. The marked radius of the inner cylinder then has absolute orientation measured from the same downward direction. Its signed spin angular velocity is , while
The moment of inertia of a uniform solid cylinder is . Applying the kinetic energy decomposition about the center of mass gives
No slip. With tangential unit vector , the inner contact point has velocity . The fixed wall requires this to vanish. Hence
Because are constant, integration gives
where the integration constant is zero with the marked-dot reference in the diagram and continuously unwrapped angles. This is a holonomic constraint, even though it was first obtained from a condition on velocities.
Oscillations. The gravitational potential energy above the lowest position is . Eliminating gives the reduced Lagrangian
The Euler-Lagrange equation becomes
Thus the bottom is a stable equilibrium, and for there is simple harmonic motion, with
The extra rotational kinetic energy reduces the frequency compared with a particle sliding without friction along the same circular path. The small oscillations inside a circular cylinder formula applies with inertia ratio .
Friction and energy. Let be the signed tangential contact force in the direction. Applying Newton's second law to translation and the torque equation to rotation gives
Using the rolling without slipping condition yields
Except at special instants, static friction is needed to produce the spin acceleration. There is no sliding at the contact point, whose instantaneous velocity is zero; therefore this force does no total work. Its translational and rotational powers cancel: . The stationary normal reaction likewise does no work. With a rigid wall, adequate static friction, and no rolling resistance, conservation of energy gives
Angular momentum. The cylinder's spin angular momentum is generally not conserved because the contact friction exerts a torque about its center of mass. About the fixed outer-cylinder center , the angular momentum decomposition about the centre of mass gives
Gravity and friction exert the external torque
Thus the rolling cylinder does not generally conserve angular momentum, although it conserves mechanical energy. There is a special geometric cancellation at : then and its torque vanish identically for this planar motion. Angular momentum of a larger isolated system including the wall and Earth is a separate conservation statement.
Scope of the holonomic reduction. The integrated constraint is exact at every angle for planar rolling without slipping with sustained contact; it is not restricted to small oscillations. Completing a full turn requires tracking angle winding rather than reducing each angle separately modulo . This global bookkeeping does not make the local velocity relation nonintegrable.
However, arbitrary initial conditions need not sustain this ideal rolling motion. The inward normal reaction and the required friction are
Contact requires , and a finite coefficient of static friction requires . If either fails, the cylinder detaches or slips and the one-coordinate rolling Lagrangian no longer applies. Slipping contact allows and to be independent; detachment removes the fixed center-distance constraint. These changes alone do not establish a nonholonomic constraint. Allowing general three-dimensional reorientation can introduce nonintegrable rolling constraints, but that motion is outside the diagram's two-angle planar model. Thus the stated planar rolling constraint is holonomic throughout its regime of validity; it cannot be imposed on every physically possible motion.
Specify the amplitude convention. For normal-stress/pressure amplitudes, the seismic reflection coefficient and seismic transmission coefficient are
For particle displacement or velocity resolved in one fixed normal coordinate, the reflected amplitude changes sign and the transmitted ratio is instead
These are alternative conventions, not conflicting energy predictions. The reflected and transmitted energy flux fractions are
which sum to one for the ideal lossless interface. Thus an amplitude transmission coefficient greater than one does not violate conservation of energy.
After bath cooling followed by insulated equilibration, the remaining mean temperature is conserved: integrating the insulated heat equation gives
For constant density, specific heat capacity and cross-section, this is conservation of energy. Its Fourier cosine series has a constant mode equal to the initial integral average; every nonconstant mode decays. Therefore the eventual uniform temperature is
For each mode with an odd integer index in part (c), . Integrating the bath-cooled series yields
For , uniform convergence justifies termwise integration; the result also follows by dominated convergence of the summable positive coefficients. As a check, gives for zero bath time, and as . More bath time strictly lowers the retained average temperature when and .
Apply the same stress-amplitude convention to S-wave seismic impedance. At limestone–sandstone,
At sandstone–salt,
A stress-amplitude transmission greater than one does not violate conservation of energy: the transmitted energy fraction includes the seismic impedance ratio. For particle velocity, the corresponding pairs are and . At normal incidence in isotropic layers, pure P and pure S waves do not undergo seismic mode conversion.